Help for a Newbie

sparkie101

New member
I have been creating routes and 3D models in MSTS since the start but have just started in Trainz. For me, the big attraction of Trainz is being able to jump from loco to loco and the ease of operation.

My problem: I deleted a section, in error. There was little on the section except there was a train. I have redone the section, but when I go into driver, the old train is there. How do I delete the old train. I have spent enough time on this that I would rather not start over.

Very low on the learning curve,
Sparkie
 
Trying a guess, you mean the old train isn't visible in Surveyor? You probably know in Surveyor hit F7 which opens up the train fly-out. Hit "C" on your keyboard which puts in you in consist mode, press "D" and click on the old train. If it's not visible in Surveyor, an artifact, press Ctrl+F, which gives you the Find window and see if you can find the name of the train. Click on that, then follow the instructions above clicking right on the center of the compass rose.
Norm
 
Norm,

You are correct. the train is not visable in surveyor but is visable in driver. The Smoke from the engine does show in surveyor.

I tried the delete where the smoke is and where the find window (compass) shows, with no success.

Thanks,
Sparkie
 
Norm,

Well I got rid of the artifact train. I deleted the sections involved and saved the deletions. When i added the sections again, the artifact was gone. Thanks for your interest.

Sparkie
 
Back
Top