Is there any possible way of adjusting the height in an entire route but keeping all the relative heights (both topography and splines) the same? I have a route I'm making with partial routes constructed separately however I have a height mismatch that I need to correct (which as far as I can figure out I'm going to have to do manually and I have alot of complex splines bunched together)
Height Adjustment
- Thread starter iain2006
- Start date
cascaderailroad
New member
You can use copy/paste height and it will raise 1 or maybe 2 baseboards ... If it is a DEM, no you can't, or it will flatten the terrain.
cascaderailroad
New member
Sorry double posted
Shortline2
Joined: 28th Oct. 2002
Hi,
Answer is yes, it is possible, but, it is not straight forward as it involves a payware program called TransDEM and a need to learn it a little. Very little I would say, but I'm sure that might vary from person to person.
Other way around is to find a friend, someone helpful not a friend, will also work, that already owns TransDEM and let them do the raise/lowering of the route and send it back to you. That is also possible.
There been some discussion of this before, not sure in which thread though.
Best wishes
Linda
Answer is yes, it is possible, but, it is not straight forward as it involves a payware program called TransDEM and a need to learn it a little. Very little I would say, but I'm sure that might vary from person to person.
Other way around is to find a friend, someone helpful not a friend, will also work, that already owns TransDEM and let them do the raise/lowering of the route and send it back to you. That is also possible.
There been some discussion of this before, not sure in which thread though.
Best wishes
Linda