DieselDesires
New member
I recently ran the update to 44088, but as I usually run the ECML session that I have made modifications to, I didn't notice all the changes.
Today I decided to see quite what had been done and I must say I am amazed. The main points I have seen are Doncaster and the Kings Cross area. Loads more trackmarks, and I would assume more signals.
The main problem I have, is that not only have I made plenty of edits to the origonal route, I have lots and lots of drivers and driver commands.
I don't mind if I have to re-do track marks and things but I really don't want to have to do my drivers again.
Questions:
Can I make my edited session point to the updated map in the config file?
Can anyone involved give me an overall run down of the changes made to the ECML in this update?
Ta muchly.
DD
EDIT:
For the benefit of others thinking the same, it doesn't work. I changed the kuid for the updated map in the session I wanted to use. After a bit of faffing about, I got it to show in the routes menu. When it started, the driver who should start at Peterborough, was placed at Doncaster, on the wrong line. Other consists were placed all over the place and derailed immediately, and the session wouldn't load properly.
Its a shame because I really would like to find a way of transferring schedules and driver commands between the old and updated maps.
Today I decided to see quite what had been done and I must say I am amazed. The main points I have seen are Doncaster and the Kings Cross area. Loads more trackmarks, and I would assume more signals.
The main problem I have, is that not only have I made plenty of edits to the origonal route, I have lots and lots of drivers and driver commands.
I don't mind if I have to re-do track marks and things but I really don't want to have to do my drivers again.
Questions:
Can I make my edited session point to the updated map in the config file?
Can anyone involved give me an overall run down of the changes made to the ECML in this update?
Ta muchly.
DD
EDIT:
For the benefit of others thinking the same, it doesn't work. I changed the kuid for the updated map in the session I wanted to use. After a bit of faffing about, I got it to show in the routes menu. When it started, the driver who should start at Peterborough, was placed at Doncaster, on the wrong line. Other consists were placed all over the place and derailed immediately, and the session wouldn't load properly.
Its a shame because I really would like to find a way of transferring schedules and driver commands between the old and updated maps.
Last edited: