scenario in examples...
1.driver is sean assigned a passenger train with specific mission code routing., basically point A to B then REPEAT command...
2.driver is david assigned a freight train with specific mission code routing....Now the freight train runs the same main line as the passenger does except it junctions off at the stations...
3.EIT TOWERS consist of 4 total...
Using the Mission Control Manager allows me to assign MCs 1 time for simplicity...
4.Once the MCs are assigned the passenger train uses DRIVE TO commands and load/unload A to B repeat...
The freight train is assigned a simple A to B routing with Drive to Trackmark.
5.driver is AMY ASSIGNED A SWITCHING LOCAL from the yard in which this train has completely different MCs also and does not run the main except crosses it at 2 points...(ALL PATHS ARE ACCURATE)
6.As I attempt to assign another train I see the passenger and switcher running different routes and theyre MC s assigned to different drivers as with different non assigned drivers now running these trains????
7.In the drivers menu view I noticed a lot of jumping around prior to this happening each time?
8.I do have the MCs range reduced to 4000 from 10000 due to trains locking towers way to early., and also set changed STATIC PATHS to DYNAMIC share(?) to keep 1 train locking up all the towers as it ran its route...
9.Then comes the Trains randomly STUCK at towers for no reason at all?
10.Recapping the set up in surveyor I noticed MCs assigned to wrong paths for different towers when I went back to see what I may have done wrong., Fix and retry operations same results...
11.Now in TANE I never have seen any of these issues arise and 1 route that I have been successful with has 30 towers and 347 paths compared to this route with 4 towers and 26 paths?
So I can only assume that some commands do not yet work correctly in TS19? Or should I report this as a new issue?
Thanx Dave =)
1.driver is sean assigned a passenger train with specific mission code routing., basically point A to B then REPEAT command...
2.driver is david assigned a freight train with specific mission code routing....Now the freight train runs the same main line as the passenger does except it junctions off at the stations...
3.EIT TOWERS consist of 4 total...
Using the Mission Control Manager allows me to assign MCs 1 time for simplicity...
4.Once the MCs are assigned the passenger train uses DRIVE TO commands and load/unload A to B repeat...
The freight train is assigned a simple A to B routing with Drive to Trackmark.
5.driver is AMY ASSIGNED A SWITCHING LOCAL from the yard in which this train has completely different MCs also and does not run the main except crosses it at 2 points...(ALL PATHS ARE ACCURATE)
6.As I attempt to assign another train I see the passenger and switcher running different routes and theyre MC s assigned to different drivers as with different non assigned drivers now running these trains????
7.In the drivers menu view I noticed a lot of jumping around prior to this happening each time?
8.I do have the MCs range reduced to 4000 from 10000 due to trains locking towers way to early., and also set changed STATIC PATHS to DYNAMIC share(?) to keep 1 train locking up all the towers as it ran its route...
9.Then comes the Trains randomly STUCK at towers for no reason at all?
10.Recapping the set up in surveyor I noticed MCs assigned to wrong paths for different towers when I went back to see what I may have done wrong., Fix and retry operations same results...
11.Now in TANE I never have seen any of these issues arise and 1 route that I have been successful with has 30 towers and 347 paths compared to this route with 4 towers and 26 paths?
So I can only assume that some commands do not yet work correctly in TS19? Or should I report this as a new issue?
Thanx Dave =)