Driver does not work.

sidingcid

New member
I have built a small layout in Trainz 12 with hills track etc. When I put a train on it and went into driver using quick drive, however, no controls came up. I tried going into user rules and selected a driver etc. but still cannot get any controls. Am I missing something very basic here? if so what?
Thanks in anticipation
Stephen.
 
TS12 does not show as registered in your station stops next to your Forum name ... only TRS2004 shows

Perhaps the particular loco is defective (as I have found many that have no interior, and no DCC control dial)

In CAB control
KB shortcuts:
4 - FreeRoam
3 - Trackside Camera
2 - Pacing camera
1 gets you into the cab, where you can press:
L - light
F - Forward
R - Reverse
W - Increase throttle
X - Decrease throttle
S - Stop
A - Apply brakes
Q - Release brakes
H - Horn
B - Bell
V - Sand
Ctrl D - Decouple

I prefer CAB mode, but DCC is much easier and has limited KB commands:
W, S, X, V, L, H, B, Ctrl D
 
Last edited:
I have got it working, finally. I don't know what I did. I have a registered Trainz, 12, should it show up? Is there anything I can do to make show?
Stephen.
 
I have got it working, finally. I don't know what I did. I have a registered Trainz, 12, should it show up? Is there anything I can do to make show?
Stephen.

Hi Stephen,

Contact the helpdesk via the link at the top of the forum. They can help you.

John
 
Back
Top