I left trs19 quite a while back, too many problems and just repurchased the game again. I thought building an AI route now will work, but I am wrong, or I am doing something awful wrong. What really ticks me off is one of Trainz's selling marks is, and I quote....."TRS19 takes you way beyond just driving trains, as you set up a fully operating railroad, managing dozens of trains under AI control, following your every instruction." Yeah right!!!
To get re-acquaintd with trs19 I setup a very simple AI controlled route with only one junction, some track marks, invisible speed signs and signals. Using the drive to or navigate to trackmark commands on trackmarks located beyond the junction not aligned with the designated trackmarks would not work. The train would not switch the junction and I get the message "no designated path". This message was constant for anything I tried afterwards. I then went through a process of elimination, removing speed signs, signals etc., without success. I finally removed the junction and the train finally went to the trackmark. During this process I am constantly switching between Driver and Surveyor using Ctl F1 and Ctl F2. I went into Edit Session and reset rules which didn't really do much that I could tell. I replaced the train driver with another and even replaced the train with no change I restarted the game and even rebooted my computer. I did not have this much difficulty with trs19 a year or so ago. I have been playi
I set up another train, track and junction on the same route. The junction was not aligned to its trackmark destination and the train did not switch the junction It stopped at the end of the track, which was very short length from the junction and reversed back out through the junction. It then switched the junction and went forward to the designated trackmark.
To get re-acquaintd with trs19 I setup a very simple AI controlled route with only one junction, some track marks, invisible speed signs and signals. Using the drive to or navigate to trackmark commands on trackmarks located beyond the junction not aligned with the designated trackmarks would not work. The train would not switch the junction and I get the message "no designated path". This message was constant for anything I tried afterwards. I then went through a process of elimination, removing speed signs, signals etc., without success. I finally removed the junction and the train finally went to the trackmark. During this process I am constantly switching between Driver and Surveyor using Ctl F1 and Ctl F2. I went into Edit Session and reset rules which didn't really do much that I could tell. I replaced the train driver with another and even replaced the train with no change I restarted the game and even rebooted my computer. I did not have this much difficulty with trs19 a year or so ago. I have been playi
I set up another train, track and junction on the same route. The junction was not aligned to its trackmark destination and the train did not switch the junction It stopped at the end of the track, which was very short length from the junction and reversed back out through the junction. It then switched the junction and went forward to the designated trackmark.