Default player engine in a session?

[sniper297]

Okay, I gotta ask cuz this is crazy. I set up a session with a few player engines, the first one I place is the default. Add AI traffic spawning from portals, test, checks okay. Want to have an AI train at the very start of the session rather than waiting for the first ones to spawn, so I place a couple of consists, edit the driver setup to add drivers and commands, save and exit. Start the session, instead of being attached to the first player train I'm attached to the first AI train that I placed.

Is there a simple way to designate the starting loco for the player?

 

[shaneturner12]

The first train in the list in Driver Setup is always the train that is selected by default when you go into Driver - make sure this one is the train you want to use as the player train.

 

[sniper297]

Thanks, that works. Had to delete the culprit driver and add him again to get him to show up at the bottom instead of the top, you would think they would have set this up so you could just drag the one you want to be the player to the top of the list.