Coal loader won't save settings

[mag315]

I have the <kuid2:439337:101033:1> Coal_Loader_Interactive_with_effects on my layout and can't figure out how to get it to save the settings I enter for it. If you set your settings in surveyor and then save your work, it works fine when you go to driver. However, if you shut down T:ANE and open it later, the loader has lost it's settings and you have to go back to surveyor and reset them before the loader will work. Does anybody have a solution to this problem?

 

[stagecoach]

This may be because the settings are saved to the session and not the route. Open the session and they should be fine.

 

[NSWGR_46Class]

Makes sure you have all the patches for TANE installed, this was an issue for some of the early builds