cannot find stations

casel

New member
Hi,,,,I am using t2006 and making a new route, I have 3 locos , 1 is picking up coal and taking it to a power station and 1 is picking up deisol and taking it to the coal mine and I have 1 loco to service to passenger stations at the moment but in the drive to command I can see the industries but not the stations , could you tell me please what Ive not done so that I can tell it what station to use.
Len
 
First question is are they passenger enabled stations? Check in surveyor to see if they are, when you click properties and then click the station you should get a window that lets you set it up.
 
Just to add to what stagecoach said....

Stations can either be a type of "industry" (will appear on the Drive To list) or may be non interactive - i.e. just scenery (and won't appear on the Drive to list). Just check what type they are - if in doubt post the KUID(s) here.

You could also add trackmarks and use the "Drive to Trackmark" command.

(this is for 2010 but I think it was the same for 2006).
 
Passanger Stations

I set up a test track to quick test Engines and Interactive stops.

If you go to pre-installed stations in pre-installed routes, you can see what they used. Use the "edit" their route to find the name of what they used.
 
Thanks for the replies and you are all correct. When I checked I wasnt using the industry stations so when I changed and also used the other stations and used drive to marker all was Ok.
Thanks again.
Len
 
Back
Top