C40-8W not appearing...

[rr325]

Yes

 

[MountE]

Did either of you contact support for assistance? support@jointedrail.com?

Mike

Yes I did and they gave me the same advise as you posted above.

Rob

 

[norfolksouthern37]

There appears to be no good reason for that not working. my suspicion at this point is that it may be because of N3V's DLC system.

install :5 and see if it clears up. http://jrpcloud.com/files/public/C40-8 engine.cdp

 

[rr325]

It works now!!!!!!!!!!!!!!!!!
Thanks a million!!!

 

[norfolksouthern37]

That confirms it then. the problem was because it was the same ID that is in the N3V DLC pack and caused it to be unusable for you.

 

[cascaderailroad]

Just out of curiosity ... couldn't you change the kuids in the original dependency: <kuid:45324:6408> ... to be <kuid:2:45324:6408:5> ?

 

[norfolksouthern37]

cascade: Possibly, but without haivng :5 it wouldnt have worked and there should be no reason to since the system should take care of it on it's own. I think it didn't work for the :4 one because it reads it as being a built-in or payware item that he does not have access to. That is why when he changed it in the config it did not show at all but had no errors.

 

[MountE]

Downloaded the :5 version and the loco now works. I always had the :4 version but dependencies for the loco showed faulty version. Now the :5 version shows in the list.
Thanks for this.
By the way ran the engine quite awhile today and really was impressed.

Rob