Built in signal problem

[peterwhite]

I am using both 'Sig LMS LP bracket home LJ 09' and 'Sig LMS LP bracket home RJ 09' which are both built in to TS12 build 58414 and I can't get them to work properly. In both instances the branch signal will operate correctly but I can't get the main signal to operate even though it shows green on the minimap and the driver goes straight through the signal with the main arm horizontal. I've tried all different targets but I've no success.
You'd think if it is built in it would work correctly.

Has anybody had any success with these signals please.

Peter

 

[shaneturner12]

If you haven't already, try the 'straight up' target. Bear in mind though that it depends on what layout you have and what kind of junction it is.

Shane

 

[captainkman]

Hi Peter,

You need to place a T-Feather asset at the junctions the signals are controlling. They are found in the same place as the signals. Look for 'Sig T-Feather' (or try without the hyphen) and place left, right or straight ones where appropriate.

Kieran.

 

[peterwhite]

Already tried that numerous time Shane but it never works.

But thanks for the suggestion.

Peter

 

[peterwhite]

Thanks Kieren but I have already done that as well.

Peter

 

[stagecoach]

I would suggest looking for Sig UQ or the Sig BR range for semaphore signals. I seem to remember one set of signals doing what you have back in 2009 version. I use bloodnoks or Chrisaw signals as these ive never had a problem with.

 

[peterwhite]

I agree Stagecoach and I am using the alternate UQ signals but I have one location where one track is lower than the adjacent track and I can't fit a UQ signal in as it is too wide. Hence my question on here.
As you say these have not worked since 2009 but they are built in, so why have they not been rectified?

Peter