Australian screenshots
- Thread starter cook
- Start date
Aologies for the above. Internet went haywire as I was trying to edit the post for the prpose of clarifying something.
Flewy, this is new to TS2010/12. Signals will show the aspects that you would expect to see if a train is approaching them. The exceptions are if a signal faces a junction, or there is a 'break' in the track between two signals. Signals will also show a full clear indication if the track leads into a portal.
Personally, I like it, for the latter reason especially. In my current WIP, in surveyor, with no trains I have ~8 kilometres of track with signal intervals of ~800m, and my only reds are the signals protecting the set of points leading to the intermodal siding. If I had no points on the route, because both ends of the route currently end in portals, my signals would show full clear indications along the entire length.
Matt.
Flewy, this is new to TS2010/12. Signals will show the aspects that you would expect to see if a train is approaching them. The exceptions are if a signal faces a junction, or there is a 'break' in the track between two signals. Signals will also show a full clear indication if the track leads into a portal.
Personally, I like it, for the latter reason especially. In my current WIP, in surveyor, with no trains I have ~8 kilometres of track with signal intervals of ~800m, and my only reds are the signals protecting the set of points leading to the intermodal siding. If I had no points on the route, because both ends of the route currently end in portals, my signals would show full clear indications along the entire length.
Matt.
laying track between NSW Border Loop and Acacia Ridge.
Acacia Ridge to the border is wonderful news :wave:
Where are the areas in the included screen shots,please?
Thanks
Peter
SARRailways
Member
Ok. I was thinking one of Davidos new NSWGR 442 Class would make a great re-skin, although it would make the other SAR Content on TRS look so out-dated
The last bend facing the NSW/QLD Border round the bend you go into the Tunnel that goes Under the border.....
That means you're way past the "bare boards with generalised generic track in place" type screen shot and in fact have a lot of authentic scenery already done as well. Bit like your Port Of Brisbane; awe inspiring
SARRailways
Member
...I don't see why there is STILL next to NO VR here!
...4a on an UP mix...
(Image removed)
Cheers
Stevo
Lovin the effect on those pics Stevo
I is,,,, just doodling, either that or help the missus in the garden:hehe::hehe: The problem with this particular mill is that what you see isnt even 50% of it, so I hope she keeps busy in the garden for a few days. When it's finished, I might send it to a few route creators.
SARRailways
Member
Last edited:
