ATLS Trigger Not Working

[AdvancedApproach]

I have an advanced ATLS Crossing setup. Eight triggers in total, four on each track, all are set to the appropriate channel. I have the triggers set up to a two-way four trigger system. The ATLS Controller and Slave are active and set up properly a too. Yet the crossings don't activate until a train is right on that crossing. How do I fix this? It's happening with only one of the crossings.

 

[AdvancedApproach]

 

[stagecoach]

It depends on the speed of the train and the distance the first trigger is away from the crossing. You can use more than 4 triggers on a track.
First trigger set half a mile away, set for priority 1 only. All fast trains using priority 1 will trigger the crossing. Second trigger 1/4 miles away, set for priority 2 only. All trains using priority 2 will pass the first trigger and only trigger the crossing at the second trigger. The third trigger on the crossing set for all priority trains.
Set up
Trigger 1 = Priority 1 Fast train
Trigger 2 = Priority 2 Normal train
Trigger 3 = Priority 3 Slow train
Trigger 4 = On the crossing set for all 3 priorities
So a total of 8 triggers could be used on one track, depending on train speed.

 

[AdvancedApproach]

It depends on the speed of the train and the distance the first trigger is away from the crossing. You can use more than 4 triggers on a track.
First trigger set half a mile away, set for priority 1 only. All fast trains using priority 1 will trigger the crossing. Second trigger 1/4 miles away, set for priority 2 only. All trains using priority 2 will pass the first trigger and only trigger the crossing at the second trigger. The third trigger on the crossing set for all priority trains.
Set up
Trigger 1 = Priority 1 Fast train
Trigger 2 = Priority 2 Normal train
Trigger 3 = Priority 3 Slow train
Trigger 4 = On the crossing set for all 3 priorities
So a total of 8 triggers could be used on one track, depending on train speed.

Upon further review it was determined that for some reason unbeknownst to me, the ATLS Trigger was assigned a channel number on route layer but not for my session. The problem has been fixed.

 

[AdvancedApproach]

@n3vgames still not working. I need answers.

 

[Firefighterdan]

Delete all the invisible tracks and start over. Go from the slave to the crossing gate, then to the traffic stopper, then to the second gate. In your screenshot, it looks like the crossing gates and the traffic stopper are not connected to the slave.

 

[bolivar]

You need to add brackets with a..b..c..etc for each trigger . Otherwise they do not function. Example : ATLS28[0,4](a), then ATLS28[0,4](b) and so on..