Up until now the only reason I'd taken a +Plus subscription was so that my Tinware Classic version of TS2019 could make use of the Unified Surveyor System. I'd never actually downloaded and installed the full +Plus version of TS2019 or TRS19. So now I've finally gone and done it and installed a copy of +Plus. Once I got past the issue of which version stream I was supposed to download everything went along swimmingly without any problems.
I have to say that I really like the new Trainz Content Store and it's a big improvement over the older black menu where the darn thing would haunt me forevermore whenever I started up TS2019. Being able to download exactly what I want into my new install, - in this case Uk DLC and Zec's Australian DLC, - and not anything else was exactly what I've wanted in Trainz for ages. And there weren't any faulty assets or missing dependencies reported in CM either.
To give my new +Plus install a test I chose the S&C route. I've got all the versions of this going back to TC3 so it was a known quantity. Yes it's old and the scenery is simple and it doesn't have any new 'magic' stuff, but I happen to like the route so it was a good beginning. My ex-lease CoolerMaster computer won't exactly set the world on fire so I'd chosen a 'Medium' setup with no shadows because I don't like strange black blobs crawling over everything.
I'm not so well at the moment so I didn't play any of the sessions, just hopped trains and played being a tourist instead. The lighting seemed to be a bit better than in my older Tinware version, though I will adjust it a bit later, - and everything ran very smoothly without any problems. So I was very surprised when I discovered this.........
About four consists floating in the air in a semicircle at one of the layout edges. Is this a known fault? - or do I need to report it?