Recent content by ianrein

Have downloaded Trainz 2022 platinum and had an order confirmed but the Mac Installer is greyed out any suggestions please?

I tried changing a piece of track and I am getting the same. problem I assume you are working on an American based route so you would be using different track anyway This seems to be an issue affecting all items in trackside mode only also seems to be route related as I have tried a simple UK...

Thanks That is not what I wanted to hear I downloaded UK Branchlines and that is. a lot of work but if that is the only way got no choice

Hi I have looked at the posts on this topic but can't solve the problem I am trying to put a speed :limit on a route but am getting Incompatible Spline message This seems to be happening throughout the route only in Trackside Mode I don’t understand why I am getting this message as there are...

Assuming the ATLS system does the same job I can see how it protects one road or track crossing but how to protect a double track converging to double track? Do I need to set this up for each crossing track ie two or can it be done on one? I need the two tracks working independent of each other...

Lewis Is that the same as ATLS? I am using 2022 Platinum and have not got ASB listed

Have tried EIT but train keeps stopping at crossing For me it seems touch and go whether the train goes through or not I don't know if it it is possible to have a trigger to do what I suggested in last post0

Hi I. have a problem protecting double track crossing double track Trainz does not recognise this setup so need a solution Have tried Interlocking Towers but a train with lower priority was waiting for a train with higher priority to cross I need a solution that would work like typical...

Hi Keith With this setup will one note at X the crossover be sufficient or do all routes need one on Points 1 and 2 as well? The problem is that paths BA and CH are not affected by X and can run through junction with X occupied but tower will not release train on HC while junction is blocked...

Ok I think I have solved the problem I was only running two trains to see the setup and the signals were staying red So I added a third train and the junction was released. There would appear to be a fail safe rule built. in that if there is no train approaching an entry signal the junction is...

Just tested this and I have the same problem My trains are running left to right and each one does not have a choice of route therefore only two paths are needed. I see what you mean though if I had trains going in both directions on both tracks I have four possible routes To sum up Train is...

Hi stagecoach Just to clarify I have two separate tracks crossing each other with no connection apart from the cross point Example X not Y I am trying just a two signal block to see how to set it up I have it set so.that when one train clears the crossing and passes the signal past the crossing...

HI I also have an Interlocking tower problem I have set the Tower up to protect a diamond crossing and I have got it working The train with priority 1 enters the junction clears it and changes the signal on other track to green So far so good. But the signal will not change to green on first...

Hi I am trying to protect diamond crossing with an Interlocking Tower I have protected the crossing and the signal goes to green to let the second train through but then the signal does not change to green on the first line again I also noticed that the Tower had a message that it was clearing...

Hi I am experimenting with boats but can not get the boat to attach to the track I downloaded Drivable Super Adaptor and that works fine without a boat It may be that the boat I am trying to move doesn't move Please give me instructions on how to set it up