Should I use these two bridges, which are bendorsey's Direct_Lift_Bridge_4, and is the only bridge on the entire route not using PBR textures, and Ben's Lower Drawbridge 1, which you wouldn't find in the southeastern United States, where this route is set, or replace the direct lift bridge with msgsapper's SAP_Low_Trestle_Spline_1T_PBR, which uses PBR textures, and the neighboring Lower Drawbridge 1 with a YARNish bridge, thereby making the stream non-navigable by boat, as the Atlantic Coast is only a quarter mile downstream. All the ground textures are PBR ground textures. Here's with the Direct lift bridge and drawbridge:
And here's with the bridges replaced:
So which one should I do? Should I make the waterway navigable or non-navigable?
And here's with the bridges replaced:
So which one should I do? Should I make the waterway navigable or non-navigable?