Is there a way to fine-tune object heights? the vehicles I place on the roads don't sit right and when I use the height adjustment its either embedded in the ground or 4 feet above the road.
Is there a way to fine-tune object heights? the vehicles I place on the roads don't sit right and when I use the height adjustment its either embedded in the ground or 4 feet above the road.
Not currently near my Trainz computer but I seem to recall that holding down the shift key while adjusting the height moves an object up/down by large increments.
Holding Shift adjusts the height of an object in increments of +/-0.05 meters. Very helpful when placing cars on a road or in a parking lot. Holding Shift while rotating an object will cause it to roll from side to side. Holding control while rotating allows you to rotate an object by increments of 0.1 degrees.
Using the mouse to adjust an objects height without any keys = up/down in 1m increments
Using the mouse to adjust an objects height with CTRL key = up/down in 0.10m increments
Using the mouse to adjust an objects height with SHIFT key = up/down in 0.05m increments