wbmfishman
New member
How do you unlock a junction. I build it in surveyor. But when I go to driver it won’t switch I get a yellow circle with a lock icon and I can’t unlock it. Any suggestions?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thank you.
Watched real close and saw the locked when train was close to junction. Can you edit trigger radius for each junction individually or do you need to delete the junction and replace it with the trigger set to 1? Is trigger same as locking?
Totally agree. There is another situation: A train has a "Drive, or navigate To" command. It approaches a set of points from one of the diverging tracks. Normally, the command will switch the points so it can pass/continue the path. But I have seen situations where the point is switched to the wrong side, and the train will sit there waiting for a change that may switch or may never happen. This situation could be due to another incoming train from the opposite side of the line taking a diverging path, and once it passes, releases the lock, the switch changes and the stopped train proceeds. So far, so very good. But some times without a train coming, the points are locked the wrong way, and the only way to fix the problem is to set the stopped train to manual, the points unlock and you proceed manually until clearing the stubborn point, then you do a continue schedule and all is normal again. My conclusion is that "Nothing is perfect.."Also remember that although you have set the radius at say 1m the actual locking distance depends on the speed of the approaching train, i.e. for a fast train it will be a considerably further distance away.