First: The run to Camp A is tricky in getting messages to come up after you get there. When you uncouple your cars and do the run around depending where you stop before coupling onto the train again you will get the message on loading the cars. If you pull the first part of the second log car to the front of trailer and stop it, it will load 2 cars at a time. You may want to experiment just where to stop. Second: Once train is loaded and you head to beaver cove to unload your ok till you get to myrtle creek switch MC2 which will show a red signal and will not change no matter how long you set there. Also you can't switch the switch by hand either. Go back to train 6251 which you passed and move that train back a bit so the switch clears so your train can proceed to beaver cove. Third: Creep into beaver cove at throttle 1 because no message came up for me to say where to unload cars. Cars will unload if you creep. Hope this was of help.
Alco_P-A
Alco_P-A
Last edited: