wierd problem

[sardon]

---Or at least it seems like it is. I have a pretty simple route built. This is 2006 by the way. Heres the thing. One time I give orders to the A/I and the train follows the speed limit good (65 mph) The next time that I do the same thing the train probably will travel at 29 mph. Nothing is different. My orders are the same and everything. Any ideas?

Don

 

[fran1]

---Or at least it seems like it is. I have a pretty simple route built. This is 2006 by the way. Heres the thing. One time I give orders to the A/I and the train follows the speed limit good (65 mph) The next time that I do the same thing the train probably will travel at 29 mph. Nothing is different. My orders are the same and everything. Any ideas?

Don

at a guess the next signal ahead is not green therefore Ai will go at approx half speed.

 

[sardon]

I would think that too except there are no signals on this loop yet. sometimes it runs at 65 and sometimes 29 with NO changes.

 

[fran1]

I would think that too except there are no signals on this loop yet. sometimes it runs at 65 and sometimes 29 with NO changes.

its looking ahead to the next signal which i guess would be the loop exit. set the train off and look at how the loop points are set, if they are set against the train 1/2 speed would seem ok,exit signal will be red or Ai can't see a signal. it will continue at 1/2 speed until a green signal.
simple solution put some signals in loop.

 

[sardon]

Thanks I'll try that


Well I tried putting signals in all pretty much spaced around my circuit but there is always one red. I wanted them to be all green for now. How can I make them all green. At this point there are no obstructions or junctions.

Don