I have downloaded some older steam engines and fixed everything so they will run in 2010 but when I load them in surveyor the wheels are turning. Can someone please help with instructions as to how to stop this? I have seen this someplace in the forums but I can't find it.
:'(I tried the fix described in the forum of taking the animation-loop-speed out of the mesh table. That did stop the wheels from turning but now they don't work in any mode. Please help. I have sent an e-mail to the creator but I don't expect an answer as they are probably inundated with e-mails.
SO I AM NOT CRAZY! It isn't just steamers. I have had some older diesels doing it too. Just wondering, are you using the multiplayer patch? For some reason, train wheels that never turned by themselves before are suddenly turning by themselves in surveyor.
I am not using the multilayer patch. This problem only occurs on locomotives or rolling stock produced for trainz below 2009. If you check the bogies config.txt file and change the animation mesh file. Delete the line that has anim.kin and animation-loop-speed 1. This should stop the wheels from turning at a stopped state. I found this information on the internet and it did the job for me.
I have downloaded some older steam engines and fixed everything so they will run in 2010 but when I load them in surveyor the wheels are turning. Can someone please help with instructions as to how to stop this? I have seen this someplace in the forums but I can't find it.