Un Portal inconsistencies

[valbridge]

Here is a problem using <kuid2:117746:1024:10> Un-Portal by sforget. In T:ANE SP3 latest build.
Maybe I have the wrong un portal installed, I dont know.

In both route surveyor and session surveyor same thing happens when entering driver to drive the session.
I would place an un portal to a trackmark, making sure it is facing the way I wish a consist to enter. Usually from a siding, but also from a main line trackmark, in session mode.

What I find is that in many instances the first trackmark added from the un portal [add] funtion will produce the required outcome. However, placing a second trackmark to the un portal rule results in just one carriage emerging!

I then tried using two [2] un portal rules to get the second [as in above] consist to emerge in its entirety. [4 carriage consist] same result one carriage only emerging. No matter in what combination the second consist always emerges as a single carriage. Varying the length of the siding did not solve the issue currently set at 930ft.

Even on a main line where sufficient distance exists between track mark and subsequent signal exists, the same outcome. With a freight train all I get is the loco emerging.

Any ideas why this is?

Cheers,
Val.

 

[pware]

There are a few threads on this issue and it does not seem to be related just to the Un-portals. I would suggest adding a standard built-in or base portal and comparing its operation.

I add that I just recently started using Un-portals in test routes and have not (yet) observed this problem.