TRS2006 Bugs - Speedo not working from No.2 End

gothmanghost

New member
I am currently using TRS2006 and have a problem in that a dual cab loco commanded from the No.2 end does not show speed on the speedo. From the No.1 end, everything is fine, but the No.2 end stays at zero. And when you drive from the No.2 end, the speedo stays at zero, but if you change views to the No.1 end whilst in transit, the speedo registers your current speed properly.
 
I backdated several higher trainz-build locos into TRS2006 and they ran, but the DCC speed dial was not there at all ... I guess I'm just lucky they ran at all ... I have no idea about TS10 ... as far as I know, a loco only has one functioning cab
 
It's a problem of the cabin script. When driving in the reverse direction, the speed could be negativ. If the cabin script doesn't use the absolute value of the speed, the dial would show zero, unless it could display negative values.

Peter
 
Back
Top