Sorry if this has been asked before but I couldn't find it. After continuing the same driving session for more than 2 sessions the TRC Traffic Stoppers do not operate the gates and allow the road vehicles to pass through the consist. Is this a known problem and if so is there a fix? They operate fine in the initial session and even after the next but after that they are not working.
TRC Assets
- Thread starter stouthm
- Start date
Are you using the TRC or TRC3 assets?
TRC3 are the updated version that work in TRS2019. The plain TRC assets don't work in TRS2019 either reliably, or at all. These will work, or appear to work in previously created routes, but when used to setup a new crossing they don't list the associated components.
TRC3 are the updated version that work in TRS2019. The plain TRC assets don't work in TRS2019 either reliably, or at all. These will work, or appear to work in previously created routes, but when used to setup a new crossing they don't list the associated components.
No luck. The gates and lights still do not work. John, you mentioned TRC3 assets but the only items I see on the dls are Enhanced TRC3 Invisible Interlocking Towers. The TRC Traffic Stoppers all have the :1 after the kuid so I'm thinking that they are the latest updated. Am I thinking wrong? I actually haven't set up a TRC asset yet ( gate and traffic stopper) so that is my next step. The problem TRC assets came with the route that I downloaded. I'll keep trying.
Look for this asset here:
<kuid2:458053:100686:16> TRC 3 Trigger for closure of rail crossing
You can download it from Vincent's website if you don't have it installed. The rest of the assets work with it. If you are using reggiestrainz crossing gates then you need to edit the config.txt file and ensure the following is correct.
category-class "WX"
custom-category-list "TRC"
The biggest problem is the category-class being incorrect.
<kuid2:458053:100686:16> TRC 3 Trigger for closure of rail crossing
You can download it from Vincent's website if you don't have it installed. The rest of the assets work with it. If you are using reggiestrainz crossing gates then you need to edit the config.txt file and ensure the following is correct.
category-class "WX"
custom-category-list "TRC"
The biggest problem is the category-class being incorrect.
Hey John, I'm not trying to beat a dead horse here but after looking into your suggestions every asset that is installed was good. Had the correct Trigger for closure and the gates are by (vincentrh) and not (reggiestrainz). The config is correct also. Just out of curiosity I ran a fresh session and all the gates and signals worked but just to add another stumper the bells were ringing even though I had chosen the option "no sound". I'm not about to replace all those gates so I'll just go with what I have for now. Maybe I'll check out Vincent's website if I can find it. Again, thanks for your time and effort.