Trainz 2006 DCC mode

[w0zzs]

I cannot get the DCC mode to work. I have done the 'abandon schedule' and the DCC-type control comes on for about 15 seconds then disappears. I would like to make all Trainz 2006 trains run under DCC. I have read the instructions over and over. Can you help please? Harold

 

[JCitron]

I cannot get the DCC mode to work. I have done the 'abandon schedule' and the DCC-type control comes on for about 15 seconds then disappears. I would like to make all Trainz 2006 trains run under DCC. I have read the instructions over and over. Can you help please? Harold

Harold,

Make sure you have that option enabled in the session before you start. This is one of the settings in Surveyor under driver setup.

John

 

[john259]

Harold,

Please excuse me if I'm insulting you, but DCC and CAB modes only apply when you are driving a train, not when it is obeying pre-programmed driver commands.

John

 

[w0zzs]

Harold,

Make sure you have that option enabled in the session before you start. This is one of the settings in Surveyor under driver setup.

John

.
Thanks, John! I did what you said and everything works fine. Harold.