Train Stopped

[JohnnyC1]

I have a locomotive that I drove in DCC mode to a Multiple Industry New Location, to load flat cars of aluminum. After loading the first 2 cars I moved forward to load the next cars in sequence. When I advanced the throttle the AI to command and has not relinquished command of the train. The other other cars were not loaded. The consist of 6 cars and locomotive will not move. Using ver. 2010.

Thanks for the help

 

[4ndylloyd]

Johnny,

I have read other posts along this theme and the problem there seemed to be that the train was trying to load but the industry does not have any goods left to load the train with. You could try increasing the initial count of your product at the industry or wait longer before your drive your train to it to load (allowing it to produce more of the product before you get there).

You could make up a train of just 2 cars, drive it to your industry and load and then see if you can continue to drive. If you can then increase the train to 3 cars and try again, if the train stops on the second attempt then it will most probably be down to the fact that there is only enough product to fill 2 cars

I am a TRS06 user and have never found this problem with my version but it may be that it now exists in 2010?

Regards, Andy

 

[JohnnyC1]

Thanks Andy, I did increase the product, with the same results. What I did was to use a single commodity for each track. That did the trick.

Johnny

 

[hert]

After you try this is there a orange/red dot in lower right of the screen?
Click that if its there and see the error message.
I think I had this happen due to a script error.

hth,
hert:wave: