Traffic Generator Showing in Driver

[jeff1959]

I've got my traffic moving along nicely on a section of 4 lane street (Austin 4l road). I'm using C+ RN TG04 1 Way Traffic Generator Carrate 04. The traffic moves like expected. However, the asset shows up in driver. If I lower it, the cars are below the street level. How to I get it so it doesn't show in driver?

This picture is taken in driver. In case it matters, this is TRS22 plus build 116069. Pay no attention to the incorrect intersection. I realized I hadn't fixed that after widening the street.

 

[JCitron]

Add in this to the config.txt

surveyor-only 1

Adding this means the attached mesh will only be visible in Surveyor and not Driver.

 

[jeff1959]

Add in this to the config.txt

surveyor-only 1

Adding this means the attached mesh will only be visible in Surveyor and not Driver.

Thank you John. You are always helping the rest of us and it is appreciated.

 

[JCitron]

You're welcome. I just ran into this the other day on a bridge asset that had a bright red stripe running down the middle of it in Driver.