Track and a Tunnel problem

[rawhide60]

Hi, Everyone,

My track problem is I was editing my layout and deleting some track when it wouldn't delete anymore. I've tried a few more times and it still will not delete.
My tunnel problem is getting a nice entrance into the tunnel. What happens is I get land and part of the tunnel showing. My tunnel is going under buildings so its not a hill. Any help would be most appreciated thank you.

Cheers rawhide60

May I take this opportunity to wish everyone A MERRY CHRISTMAS AND A HAPPY NEW YEAR

 

[carr]

Hi,

Have you tried to break the spline before deleting? Is there something near to the track you are trying to delete such as a loco or some rolling stock as this would have to be moved.
With the Tunnel, is it low enough to get under the buildings? or alternativly raise the ground and building level.

Good luck and Merry Christmas

 

[rawhide60]

Thank you carr with your help I have sorted the tunnel problem but track still will not delete so I have had to use it because it will not go. I've deleted all round were it is I've added track to it and it still won't go. If you can't beat them then join them that's what Ive done.

Cheers All the very best rawhide60

 

[cascaderailroad]

If it makes a "Kloink" sound when deleting, there is something on the track.

Put a long consist on the track, and move it back and forth, to pick up any invisible loco or car assets, then delete entire consist.

You need to be directly overhead, looking straight down, and zoomed in.

Tugging up and down on a tunnel spline will make it go right through a mountain.

There are track tunnel splines, as well as (static building) asset tunnel splines that are not under the track tab at all.

I have even laid track independently 0.02m higher, right overtop of a problematic tunnel track spline.

Tugging on the 4 grid corners (with radius set to minimum) you can fine tune a Dighole 1x1 asset