TANE - can I set/change track condition for an entire route in a single operation ...

b9k9kiwi

Member
... or (surely not) do I have to set each section of procedural track (between spline points) one section at a time.
 
Hi

Yes you can change track to procedural track but you will need to go through the route afterwards looking for red spline circles. Any that you find will need to be juggled about to get them to produce a procedural junction. Remember though that at this stage it doesn't change three way junctions or slips to procedural ones. I would suggest cloning the route and experimenting with the clone first.

Regards

Brian
 
Each Procedural Track has a default track condition defined in its config file. The value can be over-ridden in Surveyor but because it is a one-at-a-time process, it is best to have the majority of the track at the default level.

I suppose it is always possible to clone the track to create various versions at different track conditions and still have the same look to the track.
 
Back
Top