STATION WOES

[DESDICHATO]

Hi,

I am testing out a route I've built but am having hassles with platform numbering, I am using AJS invisible stations in this particular case the twin curved one, I have gone through the various instruction and have numbered all platforms in surveyor number one through to eight, not a problem, however when I try to run a loco through any platform, I select it from the dropdown menu which reads as per surveyor, but when I check it in the drivers commands it reads either platform one or two and the loco parks at platform one or two, to add insult to injury the next station (MN Goldens Bridge) along the line has a big red spot and white cross on it....in this latter case I have used it in other parts of the route without any worries.

Any thoughts anyone, how to solve this??????


Thanks

 

[dnevans8]

As well as including the platform number in the station name you also need to change the starting platform number for each of the stations in the properties box under "Station options"

The red spot with white cross means Trainz thinks you have changed the name since you set up the driver instructions. Go back to the driver setup and reselect the station that is giving problems.

 

[kenneth18278]

As above, but also use the "Call At" driver instruction instead of the "Navigate To". It's on the DLS.