Odd derailing

[Thad09]

I have been designing/making a locomotive from scratch, have the config file made and everything mapped out well on it. I am able to place the locomotive in Surveyor, but as soon as I either rotate it or go into Driver mode and press forward/reverse, it will immediately derail and show the yellow "x".

I've checked attachment points in meshes, and such and I am not sure what is causing this issue. I copied a scrip, steamscript.gs from one loco I have long since forgotten the original source.

Could it be a script issue causing the locomotive to immediately derail when rotating or trying to move it in Driver mode?

Is there something special I am missing?

I've kitbashed many locomotives/rollingstock before and I have never seen this glitch before. Only on this custom model I have been making.

 

[Thad09]

Well... did some more digging and turns out I had swapped the a.bog0 + a.bog1 positions on both the mesh file and the config file.

Issue fixed

Let this be a lesson to kitbashers and content creators... always check your a.bog_ tags in meshes and configs!