Splines in TS12SP1

[Otomar79]

Hi,

In SP1 of TS12 is something wrong with splines. I try to lay catenary and is changing direction. It's importatnt because some parts of the catenary are starting and ending differently - differnt height or terminating, etc.

I lay one spline from A to B and 2nd from C to B, but the segment A to B changes to B-A. If the line is ending with terminator, the line is re-directed and terminator is lost.


Is there a way how to disable this behaviour? (Other than not to use SP1)

 

[clam1952]

Known and somewhat annoying problem, it's in the bugs thread already. Also affects track and trackside assets, they swap sides or move to the opposite nearest spline point.
Only way is to make sure you are connecting splines in the same direction, blowed if I can remember which direction I put something in! Still using pre SP1 because of this.

 

[Scottbe8]

Also messes up track with 3rd rail. I try to make a crossover and it ends up running the third rail right through the straight track.

 

[Otomar79]

Is there a list of reported bugs? I am not able to find any.

 

[shaneturner12]

Most of the known bugs are in the TS12 SP1 Bugs thread found in the TS12 forum.

Shane