setting navigate to for trains leaving portals

billhughes

New member
I'm still a beginner at the technical settings side of trainz so please bear with me if this is a simple question.
Is it possible to setup driver rules, such as navigate to, wait for etc so that a train coming out of a portal will follow them?
 
Hi billhughes

Yes it is quite possible. I find that it is better to create the main body of the commands using the Schedule Library so that all that is needed for the train coming out from the portal is the "Copy Commands From" driver command. I wouldn't normally include an initial "Wait" command in the schedule to be copied, preferring to add that before the "Copy Commands From" command for each individual train as this gives you scope for varying the delay for individual trains.

If you use the Schedule Library rule it is then quite simple to add the same commands to any train that needs them without having to enter all of the commands individually into each drivers schedule.

Regards

Brian
 
Back
Top