Trainzisfun
Member
Hello everyone, I am having a bit of an issue that I can't seem to figure out on. So, I was just finishing creating a custom horn sound for one of my CSX locomotives from RRMods that I installed and I was able to put it on my locomotive once I cloned it and everything, but then when I tried testing the horn in a drive session to see how it sounds and if I did it good, the bell would only ring but the horn nothing. So like I am able to ring the bell and hear it but literally when I press the H for the key command of the horn on my keyboard, nothing happens or is heard. I have the platinum edition of Trainz 22 and so I am not sure if it is due to the type of build it is or I don't know. I mean before I had the platinum edition, all my horns worked and etc so I really don't know what could be the problem. Perhaps I probably formatted it incorrectly when I was editing my horn in the config file before submitting? I don't know because I usually use category-class ZH, category region USA and then the username, kind which is horn sound, the horn sound types such as horn_start, horn_loop, and the full horn file, then the thumbnails section and the brackets and the 0 and then the thumbnail image with the width being 240 and the height 180 (or maybe it was supposed to be 140 for width and then 280 for height?) and then the two brackets again. So I really don't know.
Any advice on this would help.
Any advice on this would help.
Last edited: