Protolars problem

jhportland

New member
I am using the PL warehouse to load General Ggoods etc. If I drive my train in either cab or dc mode and place it at the appropriate track point , the wagons load with or without decoupling. If I use AI to drive to a trackpoint, the wagons will not load whether I decouple or not. I have used marker poles so I know the wagons are correctly placed.
My sequence runs as follows:
Drive to trackpoint, decouple from; drive to track point; wait for 2 mins: couple to: drive to seaport gg offload; unload; drive to trackpoint. Every thin works except the loading. If after the wait I stop train and couple manualy, leaving a wagon on the pl interactive track, the train then loads.
I have used the above sequence successfully in Trainz2009. Can anyone offer advice or explanation......many thanks.......john H.
 
they work with AI only if theyre are absolutely no other commands after including wait for etc...you have to let it sit a min or so to load....
 
After the AI delivers the cars to the PL track wait a few, then in DCC move the consists a few feet fwd & aft, uncouple and DCC exit from the track.

John
 
A train can not have the wait command or the cars won't load/unload. AI need to drive to.or stop,decouple and pull away.
I have 200 of PL INDs on my USA route they all work fine in MP too.
Just to make sure i just tryied it. Drive to IND.and it loaded fine.No other commands.
 
Thanks for help , guess I was fooled because my system works in ts2009. My trains eminate from portals and carry out the full sequence. Looks like TS12 is more limited.....John H
 
Back
Top