captainkman
You are reading this.
Hi,
Recently I have been using the W & A RR locos on the DLS. General, Texas and Yonah.
Here is my problem: When I place Texas or Yonah on the track, on any route, it shows perfectly. When I go into Driver, only the smoke is visible, and only on the loco that is selected.
When I go back to Surveyor, the locos are not visible at all, and appear to be on a hidden layer.
This is only with Texas and Yonah, and no other engine or carriage, unless it is attached to either Yonah or Texas. General is not affected either.
Are there any solutions to this problem? And would anyone be interested in a Multiplayer session using these locos, and some V & T RR and W & A RR rolling stock on the DLS on the Keatons W&A RR route?
Kieran.
Recently I have been using the W & A RR locos on the DLS. General, Texas and Yonah.
Here is my problem: When I place Texas or Yonah on the track, on any route, it shows perfectly. When I go into Driver, only the smoke is visible, and only on the loco that is selected.
When I go back to Surveyor, the locos are not visible at all, and appear to be on a hidden layer.
This is only with Texas and Yonah, and no other engine or carriage, unless it is attached to either Yonah or Texas. General is not affected either.
Are there any solutions to this problem? And would anyone be interested in a Multiplayer session using these locos, and some V & T RR and W & A RR rolling stock on the DLS on the Keatons W&A RR route?
Kieran.