Problem with junctions after save driver session

[Aristides]

I have a route under construction and i start to test it in driving.
When started driving all the junctions switces worked fine.
I saved the driver session.
Later when loaded this session all the juctions switches did'nt work and the two arrows was red .Does anybody tell me what happenig with this problem?
Thanks

 

[rastis]

G'day! :wave:

Do you click on the Junctions in Driver? That switches them!

Cheers!

Jake.

 

[Aristides]

No they don't work the two arrows are red they don't switch

 

[rweber95]

Try to re-position the switch lever directly over the points. That works sometimes.

Bob

 

[fran1]

Your adding track in a session layer not the route layer. Someone had exactly the same issue.
Go into the session in surveyor and open the layers function, select the merge button (pitchfork thing). Select merge with route layer.
On exiting surveyor save as new route, just put V1 at the end of the route name. You will then have a new route with your session.
If you look very closely at your 2 red arrows you will see the point base is at a slight angle to the track.