Portals, Missions and EIT

[Hunter58]

Hi all,
I am experimenting (learning) interlocking towers and mission codes. Therefore I created a simple route with a track running from a Portal (auran, latest update) to a yard.
I have two loco's set up that should run from portal to the yard and back in an endless loop
Here is the problem and I can't find the issue:

• In the Central Portal Control rule my portal is not showing up nor can I edit it. The list is empty??
• In the Mission Code Manager rule everything is set except for the trains tab. None of the loco's shows up in there. If I open the driver rule I do see two loco's with a driver assigned?

If I drive the session a loco runs to the Yard, waits a few seconds, reversed and is running back to the portal. The portal is setup to consume and respawn on a 1 min interval.
The loco returns and in a few seconds drives back in the portal again

This is the command sequence assign to that driver:

1. Add Mission Code 'toYard'
2. ITMCassignNextPath
3. autodrive to next MCPathstop
4. wait 10 sec
5. remove missioncode
6. Change train direction
7. Navigate to portal Portal1
8. repeat commands

Any help is appreciated

Ruud