PEV's Sway utility

[kenneth18278]

I've just started using the Sway utility, and if you haven't tried it, give it a go - it is seriously good, as are all Peter's tools. They've bailed me out on many an occasion. I just have 1 very small problem, and it only applies to the Auran DLCs, notably the Princess Coronation set. When I cloned the locos to make a sway version, I had a lot of texture errors, which I just ran through Images2TGA (thanks again, Peter), which sorted it. Went into my route and session and replaced a loco. It showed up fine, I could apply the running number but the nameplate remained blank. The sway worked perfectly, and in cab view you can't see the nameplate anyway, so it's no biggie. I just wondered if anyone knew why.

Regards all

Ken

 

[cascaderailroad]

Ken it do this: http://www.youtube.com/watch?feature=player_embedded&v=lhtlgbZAzFQ

Originaly posted by Red_Shark in his 750mm NG thread

 

[kenneth18278]

Yes, the sway works perfectly, and very good it is too. The little problem is just the names don't show up on the nameplates on the side of the locos. I can get the numbers on the cab OK, but not the names. The nameplate is there but it's blank. Without the sway, on the originals, the name shows. It's just on the cloned ones with sway applied. And this only applies to the DLC pack locos, Princess Coronation, to be precise. Like I said, it isn't important, as in cab view you can't see it anyway. I was just curious why.

Regards

Ken

 

[Euphod]

Thanks for the recommendation, I'll have to look into giving the sway a go when I reskin cars. I don't drive much anymore, just to test items and sometimes not even then, but if it's that desirable then I'm sure others will want to have the feature incorporated.

 

[trainz2010vinny]

I've just started using the Sway utility, and if you haven't tried it, give it a go - it is seriously good, as are all Peter's tools. They've bailed me out on many an occasion. I just have 1 very small problem, and it only applies to the Auran DLCs, notably the Princess Coronation set. When I cloned the locos to make a sway version, I had a lot of texture errors, which I just ran through Images2TGA (thanks again, Peter), which sorted it. Went into my route and session and replaced a loco. It showed up fine, I could apply the running number but the nameplate remained blank. The sway worked perfectly, and in cab view you can't see the nameplate anyway, so it's no biggie. I just wondered if anyone knew why.

Regards all

Ken

how can i move train up and down while sitting inside a coacH ????

 

[ianwoodmore]

Jump on the seat.

 

[trainz2010vinny]

this is for trainz 2009 or 2010. BUT I HAVE 2012 version

 

[PEV]

It works in TS12, and can be applied to TS12 rolling stock assets.