Passenger Trains Blowing By Station and Getting Stuck

[AdvancedApproach]

Due to the length of my route and several crossovers for industries and yards I decided to include drive via trackmark commands, so AI won't randomly switch tracks. A westbound train twice decided to pass by the station only to get stuck about three baseboards roughly from the destination. I also noticed that the AI trains won't remove drive via trackmark commands which are followed by drive to station and will then go past said station. How do I fix this?

 

[KotangaGirl]

Try adding the 'stop' command after the 'drive to station' command.

 

[fourteen]

Or a 5mph speed limit before station

 

[AdvancedApproach]

Try adding the 'stop' command after the 'drive to station' command.

That didn't work either.

 

[JCitron]

Using track marks or direction markers for that matter will not cause the AI drivers to zing past stations unless you guide the AI drivers to take the wrong track.

I've been there, done, that, and then stared at the route and session for hours before blaming the AI being dumb drivers. Upon replacing the AI drivers and adding in commands, I then noticed that I was sending them the wrong way. Oops! Sorry guys and gals. You still can't have your job back though.

What stations are you using?
Some older ones will not work properly due to issues with the scripts.

Are you using Drive To or Navigate To?

Are you then using the Load command?

If you are using the Drive To or Navigate To without the Load command, the drivers will pass through the station like a track mark.