No drive to commands in merged route.

[railroy19]

The good old LAYERS better way to do it strikes again.

I combined a bunch of routes together like I did so many times before we had "Layers". We are not all computer programmers. And all of the industries on these routes do not show up in the driver commands. Can I rectify this problem or do I have to just live with it?

I wish they would have left good enough alone.

Bob

 

[Dermmy]

Check that the industries are actually connected still. Any Spline/Object interface (industries, mocrossings, road intersections etc) are prone to come un-joined when merging.

Truth to tell tho even if the industries are 'unjoined' they should still show as valid destinations, you just get a 'No Route to destination' message in Driver.

Worth checking anyway - stranger things have happened...

Andy

 

[ct_krogen]

make sure that, the tracks are conntected to the indes, how big is this lay out,i would l liek to see it

 

[railroy19]

That is not the problem I have checked that first. I even deleted some of the industries and installed new ones and that did not even help.
I combined three of gfishers routes and the Ozark route with some of my own routes.Even the large humpyard route just uploaded a little while ago.
I have the humpyards running ok but the industries are just dead. I have installed trackmarks all over the route and had engines navigate to all of them so the tracks are all connected for sure.

I will keep trying more solutions.
Thanks guys.
Bob