Mission Code Stops and TimeTables Manager

[bcesarec]

Hello.
I tried to use Mission Code Stops and TimeTables Manager today and I couldn't get it to work.
Firstly I created MissionCodes for trains running to and from stations. And I can drive the train myself while beeing guided by the MissionCode without any problems.
Then I wanted to make Ai train run using it and it works once: train goes from A to D and stopes at B and C on the way. The problems is, I don't know how to make it go back the same way: D->C->B->A. I tried to add the stations in the TimeTable, but the train just stays at D without moving and the path is active (signal is green).
Do you have any more resources about this except for this two wikis:
https://online.ts2009.com/mediaWiki/index.php/MissionCodes_Manager
https://online.ts2009.com/mediaWiki/index.php/Mission_Code_Stops_and_TimeTables_Manager

Also, the example listed on the wiki: EIT Demo route - UK 1 - Full session with MCTimetable is no longer available.
Do you have any other examples for it?
Thank you for answers.

 

[Tony_Hilliam]

These all look to be available:

<kuid2:61392:8402:6> EIT DemoRoute - UK 1 - Full session with MCM
<kuid2:61392:8404:6> EIT DemoRoute - UK 1 - Full session with MCM Dynamique
<kuid2:61392:8406:6> EIT DemoRoute - UK 1 - Full session with TimeTable

 

[Vostrail]

In the MCSTT Manager, did you have station D set to 'Reverse'?

 

[bcesarec]

These all look to be available:

<kuid2:61392:8402:6> EIT DemoRoute - UK 1 - Full session with MCM
<kuid2:61392:8404:6> EIT DemoRoute - UK 1 - Full session with MCM Dynamique
<kuid2:61392:8406:6> EIT DemoRoute - UK 1 - Full session with TimeTable

Thank you. It looks like I made mistake.

 

[bcesarec]

In the MCSTT Manager, did you have station D set to 'Reverse'?

Yes. I did.

 

[bcesarec]

I just tried to edit the exmple UK route to do the same and it doesn't work.
What I did in this route:
1) edited NS001 timtable and added SouthToNorth mission code
2) set to reverse on South Station
3) added Middle Station and North Station to the list below with the departure times
4) edited Driver Setup with command AutoDriveWithMCTimeTable #to last pathstop in timetable

And still the train didn't want to move after it stoped on South Station.