Missing spline with no errors

[Thai1On]

The route I'm building has developed a problem, I have a grass spline that no longer works? It is showing up as a double dashed line and when I check in CM there isn't any errors on any of the dependencies :'(. How can I remove the problem spline and replace it with another one? I know the layer it is on and I guess worst case scenario is to delete the whole layer?

Dave

 

[Dermmy]

Now that's strange! I had to revert to a previous save just recently because the track attached to the ATLS slave units appeared as a dashed line on every instance in a WIP route. Now I know that the track used is AJS Track Eraser, and I could lay a perfectly functioning length of said track alongside the dashed lines. CM showed no errors in the route, its dependencies nor specifically in the slave unit. Next step would have been an EDR, but there was so little difference between that save and the previous save of the route I simply I wrote it off as a vagarie of Trainz and carried on from the previous save.....

 

[Thai1On]

I have learned from previous mistakes to make daily CPLs of my route for just this reason. I really hate to go to a previous version as I will lose miles and 8 hours of ground textures.

Dave

 

[Dermmy]

That's exactly why I save a new version every half hour or so, almost nothing lost and I can generally remember pretty much exactly what I was doing before it went wrong

 

[BuilderBob]

Why not just delete it? Or, is the problem that you are unable to delete it for some reason? What have you tried so far for deleting it?

Have you tried turning on KUID display in Developer Options and then seelcting the spline in Surveyor, so that you can identify the object.