Looking for a Cleanup Rule

[stouthm]

While running a session I noticed some track needed changing so I allowed the consist to continue before saving the session, exiting Driver and going back into the original session I then changed the track. Went back into Driver and relized that I didn't allow the consist to go far enough so that it didn't screw up the consist. Well, it did. Didn't derail but just sits there with a big question mark over it.
Now to my question. Is there a rule that would at some point erase that consist so that I could continue my session without that consist blocking the track? I looked but only found the rule for clearing derailed consists.

 

[blueodessey]

Some Rule Kuids (might help you?)

I found some Rules,

<kuid:-25:1262> Wait for Derailment
<kuid2:121843:100282:1> Junction Derailment Prevention
<kuid:121843:100282> Junction Derailment Prevention
<kuid2:116387:4:4> Derailed Vehicle Eraser
<kuid2:60850:89003:1> Clean Up Derailed Trains

I'm not good on these particular Rules. Maybe this will help a bit.......

Got some Storm Damage to attend too, going to run now......More learned members here probably give more accurate fix/help with your situation......:wave:

Cheers