Locos not functioning in SP5 but were OK in SP4

[Tony_Howard]

I have used Peter Hicks's GNER Class 91/1 locos (<kuid2:116035:91100:1> for example) for a number of years which have functioned fine up until SP4. However in SP5 I have the following problem:- I place the loco on the track. Go to Edit Session Driver Setup and assign a driver. Then select the new loco and add driver commands. All seems to be well as you leave Edit Session. But if you now return to Edit Session the vehicle is highlighted in red and consequently cannot be used in Driver. There are no errors reported and no faulty dependencies.
I see somebody had a similar problem within the SP5 release section of the forum, where it was suggested that it may be a script problem, but this does not seem to be the case, and nobody has replied subsequently on the forum.

Can anybody offer an explanation ?

Tony Howard

 

[pware]

<kuid2:116035:91100:1> comes up as an <unknown asset> in my Trainz Plus/TRS22 SP5 build 116492.

 

[Tony_Howard]

Thanks for your reply pware. It is definitely the right kuid number. I have been using it since TRS2009 and before. I don't know why it hasn't transferred to Trainz Plus/TRS22. Do you still use TRS19 ?

Tony

 

[G.M.]

hi Tony tested here for you in TRS19SP5
the loco has some warnings, but works fine here


this is what I installed

 

[bolivar]

Hi Tony. The locomotive is functioning correctly in TRS2019 SP5, here on my end. As GM noted there are warnings but they are the same that were shown in TANE.

 

[Tony_Howard]

I have now found the problem. A while back I eventually discovered that the locos would work if you disabled eldavo's Chameleon Livery Library (What it does I have no idea). After SP5 was installed it re-enabled the library. On re-disabling it everything works fine now.

Thanks for your help.

Tony