Locomotive inspection pit

[JackDownUnder]

Where does one find inspection pits similar to this one.
If not available is anyone contemplating producing one.
If yes then could it be a spline type so variable lengths are available.
Also with stairs both ends and if possible with and without board covering.
https://i.imgur.com/hfkHMZJ.jpeg

 

[Forester1]

Here are a few on the DLS. There may be more, maybe connected with roundhouses and sheds. None of these are splines
<kuid2:210518:11208:1> EBT_Inspection_Pit
<kuid:187586:28069> Iron Lifting Gear with Pit
<kuid:236618:60236> STR_InspectionPit25m1668mmNew
<kuid:84726:38004> Inspection Pit
<kuid2:645812:6029:2> Maintenance pit small
<kuid:187586:28064> Service Pit 2 Out Side
<kuid:236618:60235> STR_InspectionPit25m1668mmOld

 

[JackDownUnder]

Many thanks Forester1.
Some are known to me however will check them all out.

 

[Piere]

There is also a repair pit, made up of a fixed asset for the ends and a track section spline to attach between them, <kuid:737614:261> Repair pit - start and <kuid:737614:262> Repair pit, which can be found here.

And the tread-plates I have used with the above, in this shot are track object, <kuid:458053:102424> Plate passage of cable, by Vincentrh, on the DLS.

Hope this helps.

Cheers,
Piere.

 

[evilcrow]

Try here http://www.roltrainz.hu/traccessories.html and look for,
FUTOHAZI SZERELOAKNA olajos, vizes betonnal

128184:27198 vag.tav 4,75m szelso
128184:27190 vag.tav 4,75m kozepso
128184:27196 vag.tav 5m kozepso
128184:27197 vag.tav 5m szelso

Plenty of other goodly stuff by "Roltrainz".

Cheers, evilcrow

 

[PortLineParker]

I use a series of spline objects to make mine; lay rail only track initially and then put two suitably dirty walls either side just below rail level, steps at either end and then a concrete floor etc. I usually finish it off by sinking a platform or similar spline to rail height to cover the gaps and add a flat surface to the surrounding area as seen below. This allows for any combination of ash pit, curved etc. as you want.

Cheers,

PLP

 

[oknotsen]

Problem with the inspection pit is the hole. Because of that, you will likely not find a spline that does the trick as the thing requires a dig hole. That will likely also be the reason most either not rotate or rotate at a 90 or 180 angle.
Or at least that was my experience while building <kuid2:645812:6029:2> Maintenance pit small.

The announced more flexible height adjustments in a future version would allow for easier creating of inspection pits as you would make the spline and manually adjust the ground height. But that's future talk.