Kuid's

[RuvanJ]

Missing this KUID on SI3D Annie 2012

Error: Dependency <kuid:44700:50226> is unknown.

Think someone can help me by sniffing it out?

 

[xcrossi]

Hello:
I don't know either.
Check cfg to see what it is.
horn?
bogy?
......

 

[narrowgauge]

It is one of mine.

In my numbering system, only bogies start with 50. the one in question is a 30" gauge Fox type bogie. You will be able to get this from the DLS
where you should always look first when something is missing.

Peter

 

[RuvanJ]

It is one of mine.

In my numbering system, only bogies start with 50. the one in question is a 30" gauge Fox type bogie. You will be able to get this from the DLS
where you should always look first when something is missing.

Peter

I checked the DLS, seems it does not come up in the search do you know where i can find it?

 

[narrowgauge]

That bogie is on the DLS but when I upgraded my content to upload it I added an extra two digits making the number <kuid2:44700:5022610:1>. Use CM to look for that, and try it. It is set to build 2.9 so it should work as-is in TS10 and TS12

If everything fails, email me via the forum and I will send you the file as soon as I can.

Peter

 

[RuvanJ]

That bogie is on the DLS but when I upgraded my content to upload it I added an extra two digits making the number <kuid2:44700:5022610:1>. Use CM to look for that, and try it. It is set to build 2.9 so it should work as-is in TS10 and TS12

If everything fails, email me via the forum and I will send you the file as soon as I can.

Peter

Unfortunately there might be a problem with the Annie 2012 carriage, cause i can't seem to find the KUID for the error anywhere in the config file and it keeps showing me the error that the kuid is missing...

 

[narrowgauge]

It helps if you will quote the KUID of the asset with the fault and where it can be obtained. You could also quote the config.txt here. I haven't any idea what Annie2012 is apart from being a carriage.

Peter

 

[captainkman]

Hi everyone,

The Annie the OP is referring to is here: http://si3d2009.jimdo.com/rolling-stock/

There is a typo in the config - the kuid might be meant to be <KUID2:44700:5022610:1>, which is the VR Fox Bogey and is on the DLS. However, this is unlikely as it is a narrow gauge bogey, and Annie runs on standard gauge tracks.

Maybe the kuid was included in the config-table by error?

If it was, then it can just be removed. Before hand though, check to see if there is another kuid referenced as a bogey, and also see if that kuid is anywhere else in the config. If there is a bogey kuid already, and the missing kuid is only on the kuid-table, delete it, save and commit.

Kieran.