Junction Missing Lever

[butter]

Okay, so I added some more baseboards to a route; quite a few actually. When my trains go into driver, they stop at a red that says there is a junction missing a lever, and it cannot plot the route.. Ive been up and down the track multiple times, and there is nothing extra.. there are not anything that would show a junction. All other junctions have there switch machines... Is there anyway to find said "junction"?

 

[NickieFoenshauge]

What if you click on the red signal? Won't it take you to the problem junction?

 

[danny5]

The best way is to put some track marks just before the signal and before the next junction and the one after.Have your driver drive to the first track mark then the next & 3rd.
If the train stopped before any of the track marks then there something wrong with the track or junction. You may have to replace the track or junction.The track may have a split in it.

 

[rgcx]

Here's a few ideas to try:

-Switch to the wire frame view (you may spot a track spline that has connected to something it shouldn't ~ a fence spline etc) sometimes the default switch lever isn't visible

-In surveyor, I will add extra trackside signals (05), then in surveyor move/slide a locomotive from block to block. This is to pinpoint where the invisible switch is.

Good luck in finding the culprit.

-My last ditch effort is to drive a loco until it derails, and or makes the "turnout noise".