The reason I ask is that I have just spent a frustrating long time trying to install a bridge. The bridge comes in at the wrong angle. It has to be rotated to connect to the tracks. I manage to get things close enough at both ends, so I move to one end to connect the tracks, then I have to rotate the other end a bit to match it up. I get it connected only to realize the OTHER end has rotated out of position. So, I try to go back and rotate that and for whatever reason I can't select it. Normally, it is hard to rotate smaller objects next to larger objects, but in this case, I have a humongous trestle bridge <kuid:44878:115981>DG:URY_Bridge_62E spanning a deep gully, and instead of the bridge rotating every rock and bush anywhere nearby is rotating. No matter if I try from above, or from the side or even from underneath. What? Now it is selecting every tiny object within a half mile over this great big bridge? It is so frustrating as all get out, so hence my question, does rotation work ANY better in Surveyor 2.0? I am about fed up with the TRS19 surveyor!