Hello,
Every time when I change something within my project, I save it with a different name.
For example if I change something 2 days ago the name would be Name13FEB14a.
If I did multiple changes on the Feb 14th the names would be Name14FEB14a, Name14FEB14b, Name14FEB14c, ...
Now, since October 20th,2013 I had a session within my project with several commands.
When I wanted to change something within my project, I did the following
Started Trainz
Selected the session within my route
Edited the session
Did my changes
Clicked on save as and gave my route another name.
Since October 20th 2013 I have been using this method and everything went fine. I could run the session and the commands were executed.
But, on February 6, something must have gone wrong.
Since that day the name of the session changed, without my intervention. I didn't give the session another name.
The commands are no longer presented whenever I run the session, although the drivers ( Atari, Andrew, Ami etc ... ) are still within the session.
I just wondered if I could get the session of October 20th,2013 within a route created in Feb 2014.
Well I did found something :
I opened the session of October 20th, 2014 in CCP, and within CCP I changed the map-kuid to a route which was made in Feb 2014.
Closed ccp and saved the changes.
I Opened Trainz and went to my route which was made in FEB 2014 and yes both sessions are available.
My question :
Is it possible to merge the 2 sessions into 1 session? Will the driver commands be available after the merge?
Best regards
Kurt :wave:
Every time when I change something within my project, I save it with a different name.
For example if I change something 2 days ago the name would be Name13FEB14a.
If I did multiple changes on the Feb 14th the names would be Name14FEB14a, Name14FEB14b, Name14FEB14c, ...
Now, since October 20th,2013 I had a session within my project with several commands.
When I wanted to change something within my project, I did the following
Started Trainz
Selected the session within my route
Edited the session
Did my changes
Clicked on save as and gave my route another name.
Since October 20th 2013 I have been using this method and everything went fine. I could run the session and the commands were executed.
But, on February 6, something must have gone wrong.
Since that day the name of the session changed, without my intervention. I didn't give the session another name.
The commands are no longer presented whenever I run the session, although the drivers ( Atari, Andrew, Ami etc ... ) are still within the session.
I just wondered if I could get the session of October 20th,2013 within a route created in Feb 2014.
Well I did found something :
I opened the session of October 20th, 2014 in CCP, and within CCP I changed the map-kuid to a route which was made in Feb 2014.
Closed ccp and saved the changes.
I Opened Trainz and went to my route which was made in FEB 2014 and yes both sessions are available.
My question :
Is it possible to merge the 2 sessions into 1 session? Will the driver commands be available after the merge?
Best regards
Kurt :wave: